Installing The Callpilot 5.0 Image - Nortel CallPilot Series Upgrade Manual

12
13

Installing the CallPilot 5.0 Image

Use the procedures in this section to install the CallPilot 5.0 Image on the
various platforms.
Installing on 201i platform
Step
1
2
3
4
5
6
Copyright © 2007–2009, Nortel Networks
.
During the reboot sequence, check the version of the BIOS on the
top of the first screen. The BIOS version must be NNCXUA07.
Tip: If the BIOS version is not NNCXUA07, then check if the J10 and
J11 jumpers are both in the top position. Power down the server,
remove the single board computer (SBC) board, and set the jumpers
to the correct position. Follow the electrostatic discharge (ESD) rules
to prevent static electricity from damaging the SBC board.
Proceed to the next section,
(page 73).
Action
Insert CallPilot Image CD 1 of 3 for the 201i platform into CD or
DVD drive.
Disconnect the CLAN cable that connects the CallPilot 201i server
to the Nortel server subnet. This isolates the system from any
undesired activity from the network, such as virus attacks. Do not
reinstall the CLAN cable until you install the antivirus software on
the CallPilot server.
Restart the CallPilot server (power off the server and then power it
on).
Result: The server reboots and displays the following prompt: BOOT
ROM DOS (Default to No in 5 seconds) (Y/N).
During boot up when prompted to boot into DOS mode, select Y.
If this step is missed or N is selected by mistake, restart the server
and try again.
Result: They system is booted to DOS and menu is appears.
Type 1 to select option 1.
At the drive A command prompt, navigate to drive Z and run the
image.bat file.
Nortel CallPilot
Upgrade and Platform Migration Guide
NN44200-400 01.12 Standard
5.0 24 April 2009
Installing the CallPilot 5.0 Image 73
"Installing the CallPilot 5.0 Image"
—End—
SCSI CD-ROM and press Enter.