Nortel CallPilot User Manual page 25

BIOS error messages
BIOS error messages appear on the video monitor. Refer to the following
table for a description of the messages.
Table 6
BIOS error messages
Error message
GA20 Error
Pri Master HDD Error
Pri Slave HDD Error
Sec Master HDD Error
Sec Slave HDD Error
ATAPI Incompatible Drive
•
•
•
•
A: Drive Error
Complementary metal-oxide
semiconductor (CMOS) Battery
Low
CMOS Display Type Wrong
CMOS Checksum Bad
CMOS Settings Wrong
CMOS Date/Time Not Set
Copyright © 2007, Nortel Networks
.
Pri Master Drive
Pri Slave Drive
Sec Master Drive
Sec Slave Drive
Nortel CallPilot
600r Server Maintenance and Diagnostics
NN44200-703 01.04 Standard
5.0 25 April 2007
Interpreting BIOS error messages 25
Description
An error occurred with Gate A20 after
switching to protected mode during
the memory test.
Could not read sector from
corresponding drive.
The corresponding drive is not
an ATAPI (Advanced Technology
Attachment Packet Interface) device.
Run Setup to make sure the device is
selected correctly.
No response from the disk drive.
The battery is losing power. Replace
the battery soon.
The display type is different from that
stored in CMOS. Check Setup to
make sure the type is correct
The CMOS checksum is incorrect.
The system can corrupt CMOS
memory. Run Setup to reset the
values.
The CMOS values are not the same
as the last boot. Either these values
are corrupted or the battery failed.
The time or date values stored in
CMOS are invalid. Run Setup to set
the correct values.