Startup Sequence Description - Nortel CallPilot User Manual

28 Chapter 3 Troubleshooting your CallPilot system
Status code
C:02
OK
P:XX failure codes
P:XX indicates a BIOS diagnostic error, where XX represents a
two-character code. If the error is a critical error, the start cycle may halt. If
the error is a noncritical error, the error code is reported in the operating
system system event log after the operating system start sequence
completes and the CallPilot 8051 device driver starts.
POST Terminal errors that result in a system halt do not appear on the HEX
display. If you cannot use the HEX display to determine the cause of a system
halt, contact your Nortel technical support representative.

Startup sequence description

Introduction
The following table describes the startup sequence and the diagnostic
stages that occur. The entire sequence occurs when you do one of the
following:
•
•
•
Copyright © 2007, Nortel Networks
.
Operation description
Initialization of the second DS30x interface
Switch acknowledgement complete
The operating system startup is complete, and
CallPilot Fault Management takes over.
Note: If CallPilot is not installed, no event is logged.
You lock the 201i against the switch backplane, and the 201i powers up.
You press Reset on the 201i server faceplate to perform a hardware
restart.
Note: If you restart the operating system by clicking the Shut Down
and Restart options, the start sequence starts at stage 9. However, the
HEX display behaves as follows:
The DOWN message remains displayed until the operating system start
sequence begins.
Nortel CallPilot
201i Server Maintenance and Diagnostics
NN44200-705 01.01 Standard
5.0 23 February 2007
Failure code
C:02
Initialization of the second
DS30x interface failed. The
first DS30x interface is OK.
CRI, FAIL, MAJ, MIN, or
WARN
ATTENTION
Nortel Networks Confidential