Removing The Server From The Switch - Nortel CallPilot User Manual

88 Chapter 7 Performing hardware maintenance and mechanical assembly
Before you begin
Shut down the server software. Then remove the server from the switch and
place it on a static-resistant surface, with the component side facing up.
If you need to replace the entire 201i server, review
(page
conducting diagnostic tests.

Removing the server from the switch

Introduction
You must remove the server from the switch before you replace the following
components:
•
•
Equipment required
The following equipment is required for this procedure:
•
•
To remove the server from the switch
Step
1
2
3
4
5
6
7
Copyright © 2007, Nortel Networks
.
89). Then review the procedures for installing the server and
hard drive
software feature key (dongle)
Note: You can replace an MPC-8 card without powering down the 201i
server.
antistatic mat
antistatic wrist strap
Action
Power down the server by unseating it from the back plane. Wait 15
seconds to complete powering down, then remove the server.
For instructions, refer to the CallPilot Installation and Configuration
Task List (NN44200-306).
Turn off the monitor.
Disconnect the monitor, keyboard, and mouse.
Power down the peripheral SCSI devices, and disconnect the SCSI
cable.
Open the lock latches at the top and bottom of the server.
Grip the faceplate, and then unseat the server from the switch. Wait
15 seconds, then remove the server.
Place the server on a clean, static-resistant surface.
Nortel CallPilot
201i Server Maintenance and Diagnostics
NN44200-705 01.01 Standard
5.0 23 February 2007
"Replacing the server"
Nortel Networks Confidential