Mercedes-Benz EQE Operator's Manual page 66

Occupant safety
64
O When using a forward-facing child restraint
system in weight group I: remove the head
restraint from the respective seat, if possible.
In addition, the backrest of the child restraint
system must lie as flat as possible against
the backrest of the vehicle seat.
After the child restraint system has been
removed, replace the head restraint immedi-
ately and adjust all head restraints correctly.
O If the head restraint of the child seat cannot
be fully extended when it is installed in the
vehicle; this will result in restrictions on the
maximum size setting for child restraint sys-
tems in weight group II or III.
Contact with the roof when the head
restraint is fully extended and locked in place
will not result in any restrictions on use.
O The child restraint system must not be put
under strain between the roof and the seat
cushion and/or be installed facing in the
wrong direction. Where possible, adjust the
seat cushion inclination accordingly.
O The child restraint system must not be put
under strain by the head restraint. Adjust the
head restraints as appropriate.
1
LATCH-type (ISOFIX) mounting bracket
Before every journey, make sure that the
#
LATCH-type (ISOFIX) child restraint system is
correctly engaged in both mounting brackets
in the vehicle.
* NOTE Damage to the seat belt for the cen-
ter seat during installation of the child
restraint system
Make sure that the seat belt is not trap-
#
ped.
Remove and stow away covers 1.
#
Attach the LATCH-type (ISOFIX) child restraint
#
system to both mounting brackets in the vehi-
cle.
After removing the child seat, reattach covers
#
1.
Fastening a Top Tether
& WARNING Risk of injury or death if the
rear seat backrests are not locked after
Top Tether belts are installed
The rear seat backrests may fold forwards
when you are driving.
As a result, child restraint systems will no lon-
ger be able to perform their intended protec-