Mercedes-Benz EQE Operator's Manual page 200

198 Driving and parking
% If the vehicle is idle for lengthy periods and
connected to the mains supply, the high-volt-
age battery will be recharged automatically as
needed or when electrical consumers are
activated (e.g. the pre-entry climate control).
Ending the alternating current charging process
(mode 2/3)
Requirements:
The distance between the key and the vehicle
R
does not exceed 3 ft (1 m).
Press charging interruption button 2.
#
The charging process is ended. Status display
1
lights up white. The vehicle socket is
unlocked.
Press and hold button 3 on the charging
#
cable connector and remove the charging
cable connector from the vehicle socket.
% If you cannot remove the charging cable con-
nector, repeat the unlocking procedure. If the
charging cable connector is still locked, con-
tact a qualified specialist workshop.
% Status display 1 indicator lamp remains lit
for some time after the charging cable con-
nector has been removed and then goes out.
Close the socket flap.
#
For vehicles with an electric socket flap,
observe the following notes on closing the
socket flap.
Remove the charging cable connector from
#
the mains socket, or from the socket on the
wallbox/charging station, and stow the vehi-
cle's charging cable safely in the vehicle
( page 188).
/
The electric socket flap closes automatically in
the following situations:
shortly after the charging cable connector has
R
been removed
after the socket flap has been tapped in the
R
direction to close it
after transmission position i, h or k has
R
been engaged