Mercedes-Benz EQE Operator's Manual page 399

Press the wheel firmly against the wheel
#
hub when screwing in the first wheel
bolt.
Tighten the wheel bolts evenly in a diagonal
#
pattern in the order indicated until they are
finger-tight.
Unscrew and remove the centering pin.
#
Tighten the last wheel bolt until it is finger-
#
tight.
Lower the vehicle ( page 397).
/
#
Lowering the vehicle after a wheel change
Requirements:
The new wheel has been mounted
R
( page 396).
/
* NOTE Risk of vehicle jack becoming trap-
ped by the AIRMATIC system
If the AIRMATIC system has released air when
raising the vehicle, the jack can become trap-
ped when the vehicle is lowered.
Start the drive system. This adapts the
#
vehicle level.
Remove the jack from under the vehicle.
#
To lower the vehicle: place the ratchet onto
#
the hexagon nut of the jack so that the letters
"AB" are visible and turn counter-clockwise.
Tighten the wheel bolts evenly in a diagonal
#
pattern in the order indicated 1
an initial maximum force of 59 lb-ft (80 Nm).
Tighten the wheel bolts evenly in a diagonal
#
pattern in the order indicated 1
the specified tightening torque of 111 lb-ft
(150 Nm).
& WARNING Risk of accident due to incor-
rect tightening torque
The wheels could come loose if the wheel
bolts or wheel nuts are not tightened to the
prescribed torque.
Ensure that the wheel bolts or wheel
#
nuts are tightened to the prescribed
tightening torque.
If you are not sure, do not move the vehi-
#
cle. Contact a qualified specialist work-
shop and have the tightening torque
checked immediately.
Check the tire pressure of the newly mounted
#
wheel and adjust it if necessary.
to 5 with %
The following does not apply if the new wheel
is an emergency spare wheel.
Vehicles with a tire pressure monitoring sys-
#
to 5 with tem: restart the tire pressure monitoring sys-
tem ( page 376).
/
Wheels and tires 397