Mercedes-Benz EQE Operator's Manual page 367

% The noise certification mode is intended
exclusively for the technical test organization.
It restricts the drive power of the vehicle and
must not be used in customer operations.
Switch on the vehicle( page 175).
# /
The transport settings are displayed.
Swipe down to select the Transport Level
#
press a.
The vehicle is raised and the Vehicle raising...
Do not drive onto ramp yet message is dis-
played for 5 seconds. The raising process can
last up to 60 seconds and can be canceled
with the G button.
When raising, do not switch off the vehicle.
#
While the vehicle is being raised, you can maneu-
ver at a maximum speed of 25 mph (40 km/h).
and
Before loading the vehicle, wait until transport
#
level has been reached and the
Level
status is shown.
% If the vehicle is raised to transport level, the
transport settings will continue to be shown
even after a restart. Operation of the driver's
display is restricted.
When the vehicle is at transport level, it is lowered
again in the following situations:
When driving faster than 25 mph (40 km/h).
R
The 12 V battery is discharged.
R
The vehicle is adjusted to the height of the last
active level.
Transporting the vehicle
Load the vehicle onto the transporter.
#
Shift the transmission to position j.
#
Use the electric parking brake to secure the
#
vehicle against rolling away.
Switch off the vehicle and the power supply.
#
Only secure the vehicle by the wheels.
#
4MATIC vehicles
Transport
Make sure that the front and rear axles come
#
to rest on the same transportation vehicle.
Breakdown assistance 365