Mercedes-Benz EQE Operator's Manual page 222

220 Driving and parking
The following information will be displayed on the
driver's display:
The length of the journey since the last break
R
The attention level determined by ATTENTION
R
ASSIST:
The more segments 1 of the circle dis-
-
played, the higher the detected attention
level.
Fewer segments 1 will be displayed in
-
the circle as the attention level decreases.
If ATTENTION ASSIST is unable to calculate the
attention level and cannot issue a warning, the
System Suspended
message will appear.
If the driver display shows a warning, a rest area
search will be offered in the multimedia system.
You can select a rest area and start navigation to
this rest area.
When you restart the vehicle, ATTENTION ASSIST
will automatically be switched on. The last selec-
ted sensitivity level will remain stored.
System limits
ATTENTION ASSIST is active in the 37 mph
(60 km/h) to 124 mph (200 km/h) speed range.
Particularly in the following situations, ATTENTION
ASSIST will function only in a restricted manner
and warnings may be delayed or not occur:
If you have been driving for less than approx-
R
imately 30 minutes.
If the road condition is poor (uneven road sur-
R
face or potholes).
If there is a strong side wind.
R
If you adopt a sporty driving style (high corner-
R
ing speeds or high rates of acceleration).
If the Steering Assist function of Active Dis-
R
tance Assist DISTRONIC is active.
If the clock is set to the incorrect time.
R
If you change lanes and vary your speed fre-
R
quently in active driving situations.
Also observe any information regarding display
messages that can be displayed on the driver's
display.
The ATTENTION ASSIST drowsiness or alertness
assessment will be reset and restarted when you
continue the journey in the following situations:
If you switch off the vehicle.
R
If you unfasten your seat belt and open the
R
driver's door (e.g. to change drivers or take a
break).
▌Setting ATTENTION ASSIST
Multimedia system:
© Settings Assistance
4 5 5
Assistance ATTENTION ASSIST
5 5
Setting the sensitivity
Select Z next to ATTENTION
#
Select Standard or Sensitive.
#
ASSIST.