Mercedes-Benz EQE Operator's Manual page 202

200 Driving and parking
Requirements:
The transmission is in position j.
R
The vehicle is unlocked or the distance
R
between the key and the vehicle does not
exceed 3 ft (1 m).
The vehicle has not been started. The õ
R
display in the driver's display is off.
The charging cable is not taut.
R
Open socket flap 1 via the EQ module of the
#
multimedia system ( page 291).
/
or
Press the center rear section of the socket
#
flap 1.
1
Socket flap swings open and status display
2 lights up white.
Vehicles with an electrical socket flap: if an obsta-
cle impedes the socket flap while it is opening,
the socket flap will close again automatically.
% When the vehicle is started (the õ display
is lit in the driver's display), socket flap
cannot be opened.
Remove socket cover 4 from the lower con-
#
nection of vehicle socket 3.
%
The CCS charging cable connector requires
both vehicle socket connections 3.
Insert the charging cable connector into vehi-
#
cle socket 3 to the stop.
Make sure that the charging cable is not taut
when inserted.
Status display 2 flashes orange and, as soon
as the high-voltage battery is charged, blue.
% When the charging sequence for the ambient
lighting is activated, the ambient lighting lights
up for approximately 30 seconds as with sta-
tus display 2 ( page 147).
/
When Sound Experience is activated, different
situations, for example the charging cable
connector being inserted and removed or the
beginning of the charging process, are
accompanied by selected sounds. For infor-
mation on Sound Experience, please refer to
the Digital Operator's Manual.
Vehicles with an electric socket flap: if a charging
1
cable is not connected to the vehicle after the
socket flap has been opened, the socket flap will
close again automatically.
When the charging cable is connected to the vehi-
cle, the vehicle cannot be started or moved.
At the start of the charging process, the charge
level display is shown in the driver's display with a
charging prediction. The charging prediction
refers to the time at which the high-voltage bat-
tery will be fully charged.