Payment System Installation - Saeco Group 500 Instruction And Maintenance Manual

6.6.6

Payment system installation

The distributor does not have a payment system;
any possible damage to the distributor itself and/
or persons and/or property deriving from its
incorrect installation are the responsibility of the
installer of the payment system.
- Remove the support bracket from the
machine (fig.57).
fig.57
fig.58
- Hook the coin mechanism to the support
brackets (fig.58).
- Fix the support with the two knobs.
- Connect the coin mechanism to the C.P.U.
board.
NB. The 24V dc coin validators and MDB
systems must be directly connected to the CPU
board; the Executive serial systems are
connected to the CPU via the interface cable
supplied with machine.
The 12V dc coin validators require a special
interface board in order to be connected to the
CPU board.
Then access the programming for the correct
settings.
Consult section “ 7.0 PROGRAMMING” in order
to verify if the parameter setting is consistent
with the system used.
English
27