Water Mains Connection - Saeco Group 500 Instruction And Maintenance Manual

English
- Position the distributor, checking the levelling
by means of the adjustable feet already
assembled on the machine (fig.26). Make
sure that the distributor does not have an
inclination of more than 2 degrees.
fig.26
The SAECO International Group declines all
responsibility for inconveniences caused as a
result of the failure to observe the above
mentioned installation norms.
If installation takes place in safety evacuation
corridors, make sure that the distributor with the
door open leaves sufficient space for individuals
to pass by (fig.25).
In order to avoid dirtying the floor as a result of
the accidental spillage of products, use, if
necessary, a protective matting sufficiently wide
to cover the operating area under the distributor.
16
6.2

Water mains connection

Before connecting the distributor to the water
mains make sure that the water :
- is drinkable (if necessary by means of test
laboratory certification);
- has a pressure ranging between 0.5 bar and
6.5 bar (otherwise use a pump or a water
pressure reducer accordingly);
- if not already present, install a tap in an
accessible position so as to separate the
apparatus from the water mains should it be
necessary (fig.27);
- let some water flow out of the tap so as to
eliminate possible traces of impurities and dirt
(fig.28);
fig.28
fig.27