Omron Sysmac FHV Series Setup Manual page 205

Name
Parallel I/O cable
Parallel I/O cable for
the conversion unit
for connector termi-
nal block
General type of the
conversion unit for
connector terminal
block
For the parallel I/O connector for the FHV-SDU30, use electric wires from AWG16 to 24.
• XW2Z-S013-£
Unfused part
1
2
34
33
*1. There are two cable lengths (L): 2 m and 5 m
FHV Series Smart Camera Setup Manual (Z408-E1)
Model Description
FH/FHV series only
XW2Z- Cable length: 2 m, 5 m
S013-£ Minimum bending radius: 10
mm
FH/FHV series only
Cable length: 0.5 m, 1 m, 1.5
XW2Z-£
m, 2 m, 3 m, 5 m
££EE
Minimum bending radius: 83.2
mm
XW2R-
-
£34GD-
T
Fused part
(70) (30)
L
6 Power Supply and I/O Interface
•
Using all I/O signals requires two of this
cable.
•
One end of the cable is a connector and
other end is flat cable.
•
Connect with the cable, ensuring not to
exceed the minimum bending radius.
•
£ in the model name, the cable length is
indicated. (2 = 2 m and 5 = 5 m)
•
Using all I/O signals requires two of this
cable.
•
Connect with the cable, ensuring not to
exceed the minimum bending radius.
•
£ in the model name, the cable length is
indicated. (050 = 0.5 m, 100 = 1 m, 150
= 1.5 m, 200 = 2 m, 300 = 3 m, 500 = 5
m)
•
The connectable terminal conversion
unit is XW2R- £ 34GD-T.
£ in the model name, the following is in-
serted: J = Phillips screw type, E = Slotted
screw type, P = Push-in type.
For details, refer to Conversion unit for
connector - terminal block for XW2R series
(G077).
(70)
*1
Note
(15)
(Unit: mm)
6-27
6