Table of Contents
Advertisement
Precautions for Correct Use
• Ensure that there is no foreign matter on the surface of the image sensor before attaching it.
• Connect the lens module to the (black) lens module connector of the Smart Camera.
• Tighten the screws in order of 1 to 4 as shown in the figure below.
• Tightening torque: 0.15 N·m
Connector for
lens module (black)
Fixing screws
(M2 Phillips-head
anti-falling screws)
3
Attach the FHV-LEM££-S cover.
Precautions for Correct Use
• Note that this is unnecessary when the lighting module, or waterproof hood is used.
• Align the orientation of the cover so that the (white) lighting module connector is covered and
not visible.
• Tightening torque: 0.54 N·m
FHV Series Smart Camera Setup Manual (Z408-E1)
Lens module
1
3
4
2
5 Installation
5
5-7
Advertisement
Table of Contents
