Omron Sysmac FHV Series Setup Manual page 166

5 Installation
Precautions for Safe Use
Installation
• This product is the module exclusively used for smart camera FHV series. Do not use it for
other purposes.
• Be sure to turn OFF the power of the smart camera itself and any peripheral devices connect-
ed to it when attaching or removing the lighting module. Failing to do so can cause equipment
malfunction or damage.
• To ensure waterproofing, follow the correct mounting method and use it only after it has been
attached in the correct order.
• Tighten the mounting screws securely with the specified torque and in the order described in
this manual.
• Take care that waterproof packing and harnesses do not catch on, or get pinched between
any parts of the case when assembling.
• Do not use waterproof packing or light shielding sheet that has been scratched, or has any
foreign matter adhering to it.
Other
• The module is specifically designed for use with the (FHV7 Series) Smart Camera. Do not
attempt to use it for any other purpose.
• Do not touch the face plate of the lighting with bare hands.
• Do not touch any exposed circuit board or electronic components with bare hands. It may re-
sult in damage to the product.
• Should you notice any abnormal odor, sound, smoke, or excessive heat emitting from the
product, immediately stop use, turn OFF the power supply, and contact your OMRON repre-
sentative.
• Do not attempt to dismantle, repair, modify, or deform the product in any way.
• When disposing of the product, treat it as industrial waste.
• Do not drop the product nor apply excessive vibration or shock to the product. Doing so may
damage the product.
• The waterproof packing is made of a rubber material. Avoid storing it in a location where rub-
ber may deteriorate easily.
Precautions for Correct Use
Maintenance
• Turn OFF the power and ensure the safety before maintenance.
• Lightly wipe off dirt with a soft cloth.
• Do not use thinner, alcohol, benzene, acetone, kerosene, etc. for cleaning this product.
Warm up Time
• When performing a precise inspection, please use after 60 minutes or more after turning on
the power supply. Since the circuit is not stable immediately after turning on the power, the
brightness may change gradually.
Camera placement
• In a hot and humid environment, Condensation may occur if stored, assembled, or used.
If cloudy, remove the lighting cover or water-proof hood and wipe off the inside with a soft
cloth.
If condensation remains, keep the product under normal temperature and normal humidity
(around 25°C and 50%RH) with its power ON for about two hours before assembling the wa-
terproof hood and lighting module.
Other
• There are two types of polarization filters corresponding to the visible light range (FHV-XPL)
and the visible light to infrared light range (FHV-XPL-IR). Please use the correct filter accord-
ing to the type of light source.
• Attach this product to the Smart Camera using its locking screws. Do not attempt to remove
the locking screws from the product as they are not intended to be completely removable.
5-16
FHV Series Smart Camera Setup Manual (Z408-E1)