Table of Contents
Advertisement
6. SR-1000 NETWORK SETUP
6. SR-1000 NETWORK SETUP
The SR-1000 Network settings can be accessed from Configuration → System sub-tab. The IPs
for the IMB network interfaces can be updated by following the steps mentioned below:
1. Login as to the SR-1000 Web UI using Maintenance access level.
2. Go to the Configuration → System → Network Configuration section.
3. By default, the
IMB Ethernet 2
interface can be reached at this IP address. The
updated as per the cinema's management network & the subsequent
Gateway
values need to be entered.
4. As an option; a Secondary
mentioned by checking the
the cinema's content network.
5. Once the IP values have been entered, click on the
their correctness.
GDC SR-1000 STANDALONE INTEGRATED MEDIA BLOCK™
INSTALLATION MANUAL
is the main IP address of the SR-1000. The Web-UI
IP address
and
Subnet Mask
IMB Ethernet 1
checkbox. This can be used to connect to
Figure 14: IMB Network Configuration (1)
- 18 -
IMB Ethernet 2
IP Address can be
Subnet Mask
for the SR-1000 can be
Validate IPs
button to check
&
nd
December 22
, 2022
Advertisement
Table of Contents
