Series 2 Projector Setup; Imb Marriage And Clearing The Service Door Tamper From The Sr-1000 - GDC Standalone IMB SR-1000 Installation Manual

8. SERIES 2 PROJECTOR SETUP

8. SERIES 2 PROJECTOR SETUP
To configure a Series 2 projector to play content with the SR-1000, follow the instructions
mentioned below:
▪
IMB Marriage must be done,
▪
Service door tamper must be cleared
▪
The projector must be set up according to the requirements of the projector manufacturer.
8.1. IMB Marriage and Clearing the Service Door Tamper
from the SR-1000
Follow the steps below to perform the marriage between the SR-1000 and to clear the service
door tamper on the SR-1000:
1. Under the Configuration tab in the menu, click the System sub-tab.
2. Go to Clear IMB Tampers section.
3. Click Marry to perform the marriage of the projector and the SR-1000.
4. Click Close to clear the door tamper errors with the projector
5. After the IMB marriage is performed and the tampers are cleared; green 'Married' and
'Closed' indicators will be shown respectively (as seen in Figure 19).
GDC SR-1000 STANDALONE INTEGRATED MEDIA BLOCK™
INSTALLATION MANUAL
Figure 19: Clear IMB tampers
- 22 -
nd
December 22 , 2022