Table of Contents
Advertisement
13. AUTOMATION SETUP
13.2. Automation setup for Projectors
The SR-1000 supports automation for Barco, Christie and NEC projectors. Follow the steps
below to configure a projector device in the server automation interface.
1. Under the Automation tab in the menu, click the Device sub-tab.
2. Under the
Device
3. Select 'PROJECTOR' as the device Type. Enter the
4. Enter the
IP Address
5. Set the correct
Model
default automation port number for the model. If the projector is a Series 2 projector, check
the 'Series 2' checkbox.
6. Enter
Login
and
Password
7. Click
Save
to save the settings.
GDC SR-1000 STANDALONE INTEGRATED MEDIA BLOCK™
INSTALLATION MANUAL
list on the left, click on the
of the projector device
of the projector. The
for the projector, if required.
Figure 38: Projector setting
Create
button.
Name
of the projector and click OK.
Port
number will automatically change to the
- 35 -
nd
December 22
, 2022
Advertisement
Table of Contents
