Table of Contents
Advertisement
8. SERIES 2 PROJECTOR SETUP
8.3. NEC Series 2 Projector
In order to configure an NEC Series 2 projector to work with the SR-1000, the following steps
must be taken:
1. Switch on the projector so that it is in 'STANDBY' mode.
2. Use the Digital Cinema Communicator for S2 Windows software provided by NEC to
connect to the projector.
3. Select [Start] → [Mode] → [Service] and enter the Service password to activate service
mode operation (as shown in ).
Figure 21: Service Mode on NEC Digital Cinema Communicator
4. Select [Setup] → [Option Slot] on the Digital Cinema Communicator and select IMB for
Slot B in Option Slot Setting (as shown in Figure 22).
Figure 22: Option slot settings on NEC Digital Cinema Communicator
5. Select [Start] → [Power] → [On] to power on the projector.
6. Clear the Service Door/Marriage Tamper on the SR-1000.
To use the SR-1000 for content playback, the INPUT source of the projector macros must be set to IMB.
GDC SR-1000 STANDALONE INTEGRATED MEDIA BLOCK™
INSTALLATION MANUAL
- 24 -
nd
December 22
, 2022
Advertisement
Table of Contents
