Epson LS-B Series Maintenance Manual page 279

M/C cable (1) Set the M/C cable as shown on the right.
NOTE
Installation

(2) Connect the following connectors in the
(3) Slide the plate to install it.
NOTE

(4) Connect the following connectors to the controller.
(5) Turn ON the Controller.
LS-B series Maintenance Rev.1
Be careful with the direction of the plate.
order as shown on the right.
Finger screws : 4-M3×10
Tightening torque : 0.6±0.1 N·m
Slide the plate until it will be parallel to the base table.
Be careful not to tighten the screws with the cables get caught on the plate.
Power cable connector Signal cable connector
LS20-B Maintenance 4. Cable
1
2
Finger Screws
4-M3×10
3
265