3-4.4 Cist Ports - ZyXEL Communications XGS3600 Series Manual

3-4.4 CIST Ports

When you implement an Spanning Tree protocol on the switch that the bridge instance. You
need to configure the CIST Ports. The section describes it allows the user to inspect the to
inspect the current STP CIST port configurations, and possibly change them as well.
Web Interface
To configure the Spanning Tree CIST Ports parameters in the web interface:
1. Click Configuration, Spanning Tree, CIST Ports
2. Scroll and evoke to set all parameters of CIST Aggregated Port
Configuration.
3. Evoke to enable or disable the STP, then scroll and evoke to set all
parameters of the CIST normal Port configuration.
4. Click the Apply to save the setting
5. If you want to cancel the setting then you need to click the Reset button.
It will revert to previously saved values
Figure 3-4.4: The STP CIST Port Configuration
XGS3600 Series User's Guide
85