Gigabit Ethernet Ports - ZyXEL Communications GS1300 Series User Manual

The following table describes the ports.
Table 6 Front Panel Connections
CONNECTOR
10M, 100M, 1G RJ-
45 Ethernet Ports
Port 1 – 9 (GS1300-
10HP)
Port 1 – 17 (GS1300-
18HP)
Port 1 – 24 (GS1300-
26HP)
10M, 100M, 1G RJ-
45 PoE Ports
Port 1 – 8 (GS1300-
10HP)
Port 1 – 16 (GS1300-
18HP)
Port 1 – 24 (GS1300-
26HP)
100M, 1G SFP Slots
Port 10 (GS1300-
10HP)
Port 18 (GS1300-
18HP)
Port 25 – 26
(GS1300-26HP)
Reset and Apply
DIP Switches

3.1.1 Gigabit Ethernet Ports

The Switch has 1000Base-T auto-negotiating, auto-crossover Ethernet ports. In 10/100/1000 Mbps Gigabit
Ethernet, the speed can be 10 Mbps, 100 Mbps or 1000 Mbps. The duplex mode can be half duplex or
full duplex.
An auto-negotiating port can detect and adjust to the optimum Ethernet speed (10/100/1000 Mbps)
and duplex mode (full duplex or half duplex) of the connected device.
An auto-crossover (auto-MDI/MDI-X) port automatically works with a straight-through or crossover
Ethernet cable.
When auto-negotiation is turned on, an Ethernet port negotiates with the peer automatically to
determine the connection speed and duplex mode. If the peer Ethernet port does not support auto-
negotiation or turns off this feature, the Switch determines the connection speed by detecting the signal
on the cable and using half duplex mode. When the Switch's auto-negotiation is turned off, an Ethernet
Chapter 3 Hardware Panels
DESCRIPTION
These are 10M/100M/1000MBase-T auto-negotiating and auto-crossover Ethernet ports.
Connect these ports to a notebook computer, a workstation, a router, an AP (Access Point),
or an Ethernet switch.
These are 10M/100M/1000MBase-T auto-negotiating and auto-crossover IEEE802.3at PoE+ 30
W ports.
Connect these ports to a PTZ (pan, tilt and zoom) camera, a router, an AP, or an Ethernet
switch.
Use SFP transceivers in these ports for high-bandwidth backbone connections.
After enabling extended range using the DIP switches, press the RESET & APPLY button to
reboot the Switch without turning the power off. Extended range on the selected PoE ports
will take effect. See Section 3.3 on page 25
Use the DIP switches to configure extended range. Extended range allows you to connect a
PD (powered device) that is up to 250 m away to a port. See
more information on extended range.
GS1300 Series User's Guide
19
for more information about the LED behavior.
Section 1.1.2 on page 7 for