ZyXEL Communications XGS3600 Series Manual page 200

Controls whether the queue is allowed to use excess bandwidth.
Queue Scheduler Weight :

Controls the weight for this queue. The default value is "17". This value is restricted to 1-
100. This parameter is only shown if "Scheduler Mode" is set to "Weighted".
Queue Scheduler Percent :

Shows the weight in percent for this queue. This parameter is only shown if "Scheduler
Mode" is set to "Weighted"
Port Shaper Enable :

Controls whether the port shaper is enabled for this switch port.
Port Shaper Rate :

Controls the rate for the port shaper. The default value is 500. This value is restricted to
100-1000000 when the "Unit" is "kbps", and it is restricted to 1-10000 when the "Unit" is
"Mbps".
. Port Shaper Unit :

Controls the unit of measure for the port shaper rate as "kbps" or "Mbps". The default value
is "kbps".
. Buttons:

Apply – Click to apply changes.
Reset- Click to undo any changes made locally and revert to previously saved
values.
XGS3600 Series User's Guide
193