Table of Contents
Advertisement
3-14.9 DSCP Translation
The section describes the switch allows you to configure the basic QoS DSCP Translation
settings for all switches. DSCP translation can be done in Ingress or Egress.
Web Interface
To configure the DSCP Translation parameters in the web interface:
1. Click Configuration, QoS, DSCP Translation
2. Scroll to set the Ingress Translate and Egress Remap DP0 and Remap
DP1 Parameters
3. Evoke to enable or disable Classify
4. Click the Apply to save the setting
5. If you want to cancel the setting then you need to click the Reset button.
It will revert to previously saved values
Figure 3-14.9: The DSCP Translation Configuration
Parameter description:
XGS3600 Series User's Guide
201
Advertisement
Table of Contents
