Table of Contents
Advertisement
3.1
Command Line Interface
The AES-100 uses text command lines as the user interface for software configuration. Before discussing the
details of configuration, the rules of the commands are listed below.
1. The command keywords are in regular
2. The command keywords must be entered exactly as shown, i.e., no abbreviations are allowed.
3. The required fields in a command are enclosed in angle brackets (
list port <port number>
means that you must specify the port number for this command.
4. The optional fields in a command are enclosed in square brackets (
config [save]
means that the field
Use of commands not documented in this manual is hazardous; you can render the system totally
3.2
Console Connection
For the initial configuration, you must use the console port. After the initial setup, you can telnet to the system to
perform additional management tasks. To connect to the console port, use an RS-232 cable to connect the AES-
100 to a serial (COM) port of a computer.
You can use any terminal emulation program, e.g., Windows' built-in HyperTerminal, with the following
parameters:
!
VT100 terminal emulation
!
9600 bps
!
No parity, 8 data bits, 1 stop bit
•
No flow control
Software Configuration
This section describes the general software configuration of the AES-100.
courier
is optional.
save
Software Configuration
font.
<>
[]
unusable.
Chapter 3
), e.g.,
), e.g.,
AES-100
3-1
Advertisement
Table of Contents
