Device; Settings; Dante Settings - Innosonix MAXX Series Manual

6.8. DEVICE

The DEVICE page offers different global settings that affect the amplifier device.

6.8.1. SETTINGS

The HOSTNAME is used in DNS for IP resolving. LOCATION is just a string to add some
additional information to the device, like where is it located.
When IDENTIFY is active, the device will visually identify itself by blinking leds. But will
automatically stop after a few seconds.
Changing the IP-TYPE requires confirmation by pressing SET CONFIG. The

web interface has to be reconnected to the new IP address.

6.8.2. DANTE SETTINGS

IDENTITY is the hostname of the integrated Dante module, as seen in the Dante
Controller.
VLAN-CONFIG determine which physical Ethernet port is connected to the amplifier
controller and Dante module board. This is also indicated by the LED between the
Ethernet ports on the device's backside. see
MODE
Switched
Redundant
Independent
Do not use the same hostname for the amplifier and the Dante Module if

using Switched or Redundant mode since the mDNS hostname resolve
protocol will not be able to determine the IP address of the devices.
2023-01-05 | Rev. 3.17.0
NETWORK MODES
LED COLOUR
GREEN
YELLOW
BLUE
MAXX/HP²
Chapter 6. WEBSITE
6.8. DEVICE
6.8. DEVICE | 67/86