Table of Contents
Advertisement
3.4 CONFIGURING THE GRAPHIC HMI
3.4.1 LCD contrast
The Graphic HMI LCD contrast is set by the parameter P0490, which is accessible through the HMI group <29
HMI> or the group <09 StartUp Guiado>. Typical contrast values are between 50 and 100.
NOTE!
After the power on, approximately 60 seconds are necessary for the stabilization of the contrast at the
level adjusted in P0490. In certain climatic conditions (temperature/humidity), contrast stabilization
times longer than 60 may occur.
3.4.2 Configuring the HMI Commands
For the Graphic HMI commands to work properly, it is necessary to program the local or remote (LOC/REM) inverter
commands to be of the 'Graphic HMI' type.
Example of LOCAL configuration:
P0220 = 11 (Graphic HMI
P0221 = 0 (Key
and
P0223 = 12 (Graphic HMI
|
P0224 = 5 (Graphic HMI
P0225 = 6 (Graphic HMI
JOG
Example of REMOTE configuration::
P0220 = 12 (Graphic HMI
P0222 = 0 (Key
and
P0226 = 12 (Graphic HMI
P0227 = 5 (Graphic HMI
|
P0228 = 6 (Graphic HMI
JOG
The automatic programming of the parameters described above may be done through the parameter P0491
"Graphic HMI configuration" (Menu <10 Auto-Setup> or <29 HMI>).
Motor Rdy
P0202
Control type
[000] V/f 60 Hz scalar
[001] V/f 50 Hz scalar
[002] Adjustable V/F Scalar
[003] Sensorless Vector
[004] Vector with Encoder
Exit
13:38
Figure 3.9: Alphanumerical edition
LOC
key (LOCAL Default)).
REM
of service HMI) or 13 (Graphic HMI
key (Forward)).
O
and
key).
key).
LOC
key (REMOTE Default)).
REM
of service HMI) or 13 (Graphic HMI
key (Forward)).
O
and
key).
key).
Table 3.3: Graphic HMI commands selection
Option
000
001
002
KEYPAD (HMI) OPERATION
0rpm
LOC
Save
and
key).
and
key).
Description
Inactive
Local Graphic HMI
Remote Graphic HMI
3
MVW3000 | 3-9
Advertisement
Table of Contents
