Quick Reference Of Parameters And Faults; Parameters - WEG MVW3000 Programming Manual

QUICK REFERENCE OF PARAMETERS AND FAULTS

Software: V1.0X
Application:
Model:
Serial number:
Responsible:
Date: / / .

PARAMETERS

Param. Description
P0000 Parameter access password
P0001 Motor speed reference
P0002 Motor Speed
P0003 Motor Current
P0005 Motor Frequency
P0006 VFD Status
P0007 Inverter output voltage
P0009 Motor Torque
P0010 Inverter output power
P0012 Digital inputs DI1 to DI10 status
P0013 Digital outputs DO1 to RL5 status
P0018 Value of analog input AI1 (single-pole,
MVC4)
P0019 Value of analog input AI2 (two-pole
MVC4 board)
QUICK REFERENCE OF PARAMETERS AND FAULTS
Adjustable range
0 to 999
Read-only parameter (rpm)
Read-only parameter (rpm)
Read-only parameter (A)
Read-only parameter (Hz)
0 = Booting
1 = Sub
2 = Inveter ready
3 = Motor Mag.
4 = Motor ready
5 = Up Ramp
6 = Down Ramp
7 = In reference
8 = Not used
9 = Coast
10 = Ride-Through
11 = Flying Start
12 = Test Mode
13 = Invertes test state
14 = Not used
15 = Not used
16 = Fault
17 = Alarm
18 = Calibration process
19 = Hold
20 = I Limit
21 = fast current limitation
22 = Ride-Through without interruption
23 = Hold 2
24 = Synchronized with the line
25 = Fast disable
26 = Trying to synchronize with the line
27 = Not used
28 = Not used
Read-only parameter (V)
Read-only parameter (%)
Read-only parameter (kW)
-
-
Read-only parameter (%)
Read-only parameter (%)
0
Factory Pag.
setting
0 4-1
- 4-1
- 4-1
- 4-2
- 4-2
- 4-2
- 4-3
- 4-3
- 4-4
- 4-4
- 4-4
- 4-4
- 4-4
MVW3000 | 0-9