SETUP
LINKING THE READER
Link Datalogic Devices to Base
Before configuring the interface it is necessary to link the handheld with the base.
To link the handheld and the base simply put it into the base. If the reader was previ-
ously linked to another base, you must first scan the Unlink bar code before re-linking to
the new base.
Link Reader as Serial Device to a Bluetooth Host
Use this procedure to let the reader communicate with a Bluetooth host using the Blue-
tooth Serial Port Profile (SPP).
1. If using a Bluetooth adapter on the host device, install any driver provided with
2. Scan the Link to Host in SPP mode label below to make the reader visible to the
3. Use the Bluetooth manager of the host device to "Discover new devices" and
4. Use an RS-232 terminal program to see incoming data on the port designated by
Link Reader as HID device to a Bluetooth host
Use this procedure to send data to a Bluetooth host using the Bluetooth HID profile.
1. If using a Bluetooth adapter on the host device, install any driver provided with
2. Scan the Link to Host in HID mode label below to make the reader visible to the
3. Use the Bluetooth manager of the host device to "Discover new devices" and
4. On the host device, open the program that is meant to receive the incoming data.
The data transmitted by the reader will appear in the program as if it was typed using
the keyboard of the host device.
24
GRYPHON™ I GD/GBT/GM4500
the adapter.
host device.
select "GBT4500...". If you receive an error message, it may be necessary to
change the security settings on either the host device or the reader.
the Bluetooth manager of the host device.
the adapter.
host device.
select "GBT4500 ...". If you receive an error message, it may be necessary to
change the security settings on either the host device or the reader.
Unlink
Link to Host in SPP Mode
Link to Host in HID mode