Led And Beeper Indicators; Good Read Led Duration - Datalogic Gryphon 2D Series Reference Manual

REFERENCES

LED AND BEEPER INDICATORS

Good Read LED Duration

This feature specifies the amount of time that the Good Read LED remains on following
a good read. The good read LED on time can be set within a range of 10 milliseconds to
2,550 milliseconds (0.001 to 2.55 seconds) in 100ms increments.
Follow these instructions to set this feature:
1. Determine the desired setting in milliseconds. A setting of 0 means that the good
2. Divide the desired setting by 10 (setting is in 100ms increments). Pad the result
3. Go to
4. Scan the bar code: SELECT GOOD READ LED DURATION SETTING.
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
This completes the procedure. See the following table for some examples of how to set
this feature.
Table 21 Good Read LED Duration Setting Example
STEP
1 Desired Setting
Divide by 10 (and pad with lead-
2
ing zeroes)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT GOOD READ LED DURATION SETTING
Scan three characters from
5
Appendix D
6 Scan ENTER/EXIT PROGRAMMING MODE
290
GRYPHON™ I GD/GBT/GM4500
read LED stays on until the next time the trigger is pulled.
with leading zeroes to yield three digits. For example: 0 = 000, 5 = 000, 20 = 020,
etc.
and scan the ENTER/EXIT PROGRAMMING MODE bar code to enter
page 109
Programming Mode.
duration which was determined in the steps above. You will hear a two-beep indi-
cation after the last character.
NOTE: If you make a mistake before the last character, scan the CANCEL
bar code to abort and not save the entry string. You can then start again at
the beginning.
ACTION EXAMPLES
Good Read
LED stays on
20ms
until next trig-
ger pull (00)
000 002
'0', '0' and '0' '0', '0' and '2' '0', '1' and '5' '2', '5' and '5'
, that represent the
Appendix D
2550ms
150ms
(2.55 sec.)
015 255