Appendix B: Wireless Router Setup; To Use The Wireless Router - ABB ICOS GLA431-MCIA User Manual

USER MANUAL | ICOS | INSTRUCTIONS | UM/ICOS-EN REV. B.2
Appendix B:
A GL-MT300N-V2 Mini Smart Router is provided for use when the Local Area Network (LAN)
is not available. When Wi-Fi is ON, the analyzer will obtain a Dynamic Host Configuration
Protocol (DHCP) address from the router. The user can plug any Windows computer into
the same broadband router to access the data directory.
The router is pre-configured and assigns an IP address to its' specific analyzer.

To use the wireless router:

1. Connect the provided GL-MT300N-V2 Mini Smart Router:
a. Connect the white cable from the Power port of the router to a USB port on
the analyzer. (Figure below)
b. Connect the provided Ethernet cable from the analyzer to the LAN port on
the wireless router. (Figure below)
2. Reboot the analyzer.
3. The analyzer IP address will be in the format 192.168.8.XXX, and will be displayed on
the Time/Files screen. (Figure 52) To access this screen, press the Setup button on
the User Interface Control Bar . (Figure 51)
Figure 51: Setup button on the User Interface Control Bar
Wireless Router Setup
Figure 50: GL-MT300N-V2 Mini Smart Router
64