Table of Contents
Advertisement
USER MANUAL | ICOS | INSTRUCTIONS | UM/ICOS-EN REV. B.2
Septa (Box of 50)
•
A septum puller
•
Hardware Setup
Setup the External Connections:
1.
Connect the External Pump:
a. Connect the pump's power cord from the pump to the EXT. PUMP POWER
port on the back panel of the analyzer.
b. Connect the provided 6' x 3/8" Teflon tubing with Swagelok fittings from
the external pump to the TO EXT PUMP port on the back panel of the
analyzer.
c.
Connect the provided exhaust muffler to the exhaust port of the pump to
exhaust into the room air, or route to your facility ventilation system.
2. Connect your Zero-Air source to the ¼" Swagelok Zero-Air Inlet port on the back
panel of the analyzer. (Figure 112)
a. Zero-Air flow should be set between 5 and 10 psig.
The pretreatment box is not used for batch operation.
Figure 112: External Batch Connections
100
Advertisement
Table of Contents
