ABB ICOS GLA431-MCIA User Manual page 101

USER MANUAL | ICOS | INSTRUCTIONS | UM/ICOS-EN REV. B.2
Software Setup
1. If applicable, in the parameter window of the User Interface Control Bar , verify that
the optional MIU is not enabled. (Figure 113)
a. Disable the Multi-Port Inlet Unit (MIU) if your analyzer is configured with this
optional accessory. To disable the MIU:
i.
Figure 113: Setup Button on the User Interface Control Bar
ii.
iii.
iv.
v.
Figure 114: Control Menu for the (Optional) Multi-Port Inlet Unit (MIU)
Click Setup on the User Interface Control Bar . (Figure 113)
Click on the MIU tab at the top of the Setup screen. (Figure 114)
Uncheck the checkbox at the bottom of the screen to disable the
MIU. (Figure 114)
Click Save Changes. (Figure 114)
Click Close to exit the Setup menu. (Figure 114)
101