Table of Contents
Advertisement
USER MANUAL | ICOS | INSTRUCTIONS | UM/ICOS-EN REV. B.2
Appendix A:
Ethernet
Appendix B explains how to access the analyzer data directory as a Windows Share using an
Ethernet connection on a local area network (LAN).
The data files stored on the internal hard disk drive of the analyzer can be accessed as a
Windows Share over a Local Area Network (LAN) Ethernet connection. For this function to
operate, the analyzer must:
Be connected to a Local Area Network (LAN) via the RJ-45 Ethernet connection on
•
the back panel of the analyzer.
Receive a response to a DHCP (Dynamic Host Configuration Protocol) request when
•
the analyzer is initialized.
If the analyzer does not receive a reply, the analyzer:
Disables the Ethernet port.
•
Does not attempt another DHCP request until the analyzer is restarted.
•
When both conditions are met, the data directory can be accessed using a Windows
computer on the same LAN.
To access the data directory:
1.
Click Start > Run, and enter the IP address of the analyzer:
Example: \\172.25.34.29
Refer to the Time/Files menu (Figure 36) for the location of the analyzers' IP
address.
2. Click OK.
3. Within 10 to 60 seconds, the Windows Share directory displays the subdirectory
lgrdata.
Double-click on the lgrdata directory to see a listing of the data files stored on the
internal hard drive of the analyzer.
Open or transfer any of the data files, as you would with any Windows share drive.
Accessing Data Using the
62
Advertisement
Table of Contents
