USER MANUAL | ICOS | INSTRUCTIONS | UM/ICOS-EN REV. B.2
Standard Components
This section describes the analyzer components. Verify that each of the system
components has arrived before installation.
The standard components include:
Basic free-flow system:
Analyzer
•
Analyzer power cord
•
User guide (this document)
•
USB flash drive
•
Serial port connection cable (null modem type)
•
Exhaust Muffler
•
Pretreatment box:
•
One - 6' x ¼"
o
Two - 6' x 3/8"
o
External pump (ACC DP3H)
•
Pump connection kit
o
Pump slave power cord
o
Pump orifice for low flow mode.
•
Optional Components
Multiport Inlet Unit (8 or 16 channels)
Power Cable for MIU
•
25-pin connection cable for control signal
•
Batch injection system
Syringe injection port
•
140mL syringe
•
Centering needle
•
Septa (box of 50)
•
Septum Puller
•
Dilution Control System (EDDS)
Control Cable
•
Sample Line
•
One 6' x ¼" Zero-air (connects to house air supply)
•
Line to sample supply
•
Tee connector for the analyzer inlet port
•
This analyzer has been CE certified using data cables three meters long or
less. Connecting the analyzer using longer data-cables is not
recommended.
If you have not received all of these components, contact ABB-LGR at
icos.support@ca.abb.com.
13