Table of Contents
Advertisement
USER MANUAL | ICOS | INSTRUCTIONS | UM/ICOS-EN REV. B.2
Enable the EDDS
Click Setup on the User Interface Control Bar . (Figure 109)
1.
Figure 109: Setup button on the User Interface Control Bar
2. Click on the DCS tab at the top of the Setup menu selection bar. (Figure 110)
3. Use the radio buttons to Enable or Disable the EDDS.
4. Use the drop down selection box to set the dilution factor.
5. Click Save.
6. Click Close to begin the dilution.
Figure 110 shows the DCS Screen for the EDDS enabled.
Figure 110: Enable EDDS
98
Advertisement
Table of Contents
