Table of Contents
Advertisement
USER MANUAL | ICOS | INSTRUCTIONS | UM/ICOS-EN REV. B.2
2
Analyzer Setup
Connect the Power Cords
1.
Connect the analyzer power cord from the AC power port on the back panel to a
grounded outlet of your power supply. (Figure 3)
2. Connect the External pump's power cord from the pump to the EXT. PUMP POWER
port on the back panel of the analyzer. (Figure 3)
Connect the Data Interface Connections
1.
See Figure 5 for a detailed description of the connections.
Connect the Inlet/Outlet Plumbing Connections
1.
Uncap the INLET port on the back panel of the analyzer.
a) If applicable, connect a ¼" sample tube (not provided) from the INLET port
to your sample source.
2. Connect the External Pump's 6' x 3/8" Teflon tubing with Swagelok fittings from
the external pump to the TO EXT PUMP port on the back panel of the analyzer.
(Figure 3)
3. The exhaust port is located on the pump. It can either be connected to the
provided muffler to expel exhaust into the room air, or the exhaust can be routed to
the facility ventilation system.
Figure 11: Exhaust Muffler
21
Advertisement
Table of Contents
