Dräger Infinity Series User Manual page 130

End Tidal CO (etCO
2
Message: etCO Sensor
2
Temp Not Stable
Parameter value: ***
Message: Check etCO2
Check Airway Adapter/
Cal.
Parameter value: ***
Message: etCO
2
Calibrating Sensor
Parameter value:
<blank>
Message: etCO Cannot
2
Cal. Sensor
Parameter value: ***
Message: etCO Adapter
2
Failure
Parameter value: ***
Message: etCO Place
2
Sensor On Ref Cell
Parameter value:
<value>
Message: etCO Sensor
2
Cal. Failed
Parameter value: ***
Message: etCO
2
Verifying Sensor Cal
Parameter value: ***
Message: etCO Sensor
2
Cal. Verified
Parameter value:
<value>
Page 5-26
), Inspired CO (iCO
2 2
The sensor temperature is
unstable following warm-
up.
Airway adapter is dirty, not
fully seated, or out or
calibration.
Calibrating on zero cell.
Calibration on zero cell
could not be completed
because of C
APNOSTAT
temperature instability.
Airway adapter is dirty, not
fully seated, or out of
calibration.
Calibration on zero cell
completed successfully.
Calibration on zero cell
failed.
Calibrating on reference
cell.
Verification completed
successfully.
Infinity Gamma Series
), and RRc
(continued)
2
• Wait at least three min-
utes for the message to
disappear. If the mes-
sage persists, replace
the reusable sensor.
• Make sure the adapter
is properly seated.
• Clean and calibrate the
airway adapter.
• Informational mes-
sage; no action
required.
• Check for any heat
sources warming the
sensor and remove
them.
• Wait at least three min-
utes for the tempera-
ture to stabilize.
• Make sure the adapter
is properly seated.
• Clean and calibrate the
reusable airway
adapter.
• Place sensor on the
reference cell and wait
for calibration to com-
plete.
• Recalibrate. If the mes-
sage persists, try a new
sensor.
• Informational mes-
sage; no action
required.
• Informational mes-
sage; no action
required.
VF4