Removing The Power Module From The Device; Inserting / Replacing The Sd Card - Primedic HeartSave Operating Instructions Manual

3.3.2 Removing the power module from the device

Fig. 12: Removing the battery
Procedure:
 Lay the device on its back.
 Press the release button (2) far to the right as far as the power module tab is
unlocked and the power module (1) snaps out from the bay.
 Twist the power module slightly in the direction of the arrow (4) and then pull it in the
direction of the arrow (3) out of the device.

3.4 Inserting / replacing the SD card

Fig. 13: Inserting / replacing the SD-card
To remove or change to the SD card, you must first remove the power module.
Procedure:
 Insert the SD card into the card slot.
Note Make sure that the contacts on the SD card show upwards!
METRAX GmbH
Preparatory measures before (initial) start-up
23560 HeartSave AED Trainer / GB / B02 13 / 24