Table of Contents
Advertisement
• Read "Installation guidelines" on page 57 to ensure that you work safely.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://youtube.com/playlist?list=PLYV5R7hVcs-DoEcxrm2zKNpaKOdZ3f8Qc
• Youku:
https://list.youku.com/albumlist/show/id_59636516
Procedure
Step 1.
Install the front bezel.
Figure 73. Front bezel installation
a.
Align the three plastic tabs on the right side of the front bezel with the corresponding holes
in the chassis.
b.
Pivot the front bezel inward until it snaps into position on the left side.
After you finish
1. Reinstall the front door. See "Install the front door" on page 109.
2. Reinstall the server cover. See "Install the server cover" on page 190.
3. Complete the parts replacement. See "Complete the parts replacement" on page 206.
Front door replacement
Use this information to remove and install the front door.
Note: This section applies only to server models that have a front door installed.
Remove the front door
Use this information to remove the front door.
About this task
.
Chapter 4
Hardware replacement procedures
107
Advertisement
Table of Contents
