3. Reinstall the front door. See "Install the front door" on page 109.
4. Reinstall the server cover. See "Install the server cover" on page 190.
5. Complete the parts replacement. See "Complete the parts replacement" on page 206.
Optical drive or tape drive replacement
Use this information to remove and install the optical drive or tape drive.
Note: This section applies only to server models that have an optical drive or a tape drive installed.
Remove an optical drive or a tape drive
Use this information to remove an optical drive or a tape drive.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
S006
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or transmitters) are
installed, note the following:
• Do not remove the covers. Removing the covers of the laser product could result in exposure to
hazardous laser radiation. There are no serviceable parts inside the device.
• Use of controls or adjustments or performance of procedures other than those specified herein
might result in hazardous radiation exposure.
S007
CAUTION:
This product contains a Class 1M laser. Do not view directly with optical instruments.
.
Chapter 4
Hardware replacement procedures
147