Table of Contents
Advertisement
Figure 130. Power distribution board removal
a.
Remove the three screws that secure the power distribution board to the chassis.
b.
Slide the power distribution board towards the rear of the server to release it from the
chassis; then, carefully hold the power distribution board by its edges and lift the power
distribution board out of the chassis.
After you finish
• Install a power distribution board. See "Install the power distribution board" on page 168.
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the power distribution board
Use this information to install the power distribution board.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
ThinkSystem ST650 V2 Maintenance Manual
168
Advertisement
Table of Contents
