Table of Contents
Advertisement
o.
Make note of where the cables are connected to the system board; then, disconnect all the
cables.
Note: Disengage all latches, cable clips, release tabs, or locks on cable connectors
beforehand. Failing to release them before removing the cables will damage the cable
connectors on the system board. Any damage to the cable connectors may require replacing
the system board.
Step 2.
Remove the nine screws that secure the system board.
Figure 150. System board screws removal
Step 3.
Move the system board towards the front of the server. Ensure that the rear connectors on the
system board are disengaged from the corresponding holes in the rear panel.
ThinkSystem ST650 V2 Maintenance Manual
194
Advertisement
Table of Contents
