Table of Contents
Advertisement
Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with
metal, which might result in spattered metal, burns, or both.
Attention:
• Read "Installation guidelines" on page 57 to ensure that you work safely.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://youtube.com/playlist?list=PLYV5R7hVcs-DoEcxrm2zKNpaKOdZ3f8Qc
• Youku:
https://list.youku.com/albumlist/show/id_59636516
Procedure
Step 1.
Locate the required fan slot in the fan cage.
Note: Ensure that you observe the installation rules and sequence in "Technical rules for system
fans" in the ThinkSystem ST650 V2 Setup Guide.
Step 2.
Align the fan over the fan slot in the fan cage assembly.
Step 3.
Insert the fan into the fan cage assembly until it clicks into place.
Figure 60. Hot-swap fan installation
After you finish
1. Reinstall the server cover. See "Install the server cover" on page 190.
2. Complete the parts replacement. See "Complete the parts replacement" on page 206.
Remove the fan cage assembly
Use this procedure to remove the fan cage assembly.
About this task
S002
.
Chapter 4
Hardware replacement procedures
95
Advertisement
Table of Contents
