Table of Contents
Advertisement
Figure 41. Removal of the 3.5-inch hot-swap drive backplane
a.
Open the plunger that secures the backplane.
b.
Slightly slide the backplane as shown to disengage it from the drive cage; then, remove the
backplane from the drive cage.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install a 3.5-inch hot-swap drive backplane
Use this information to install a 3.5-inch hot-swap drive backplane.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read "Installation guidelines" on page 57 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
ThinkSystem ST650 V2 Maintenance Manual
68
Advertisement
Table of Contents
