Refilling Loading Module Of Bnr Advance Note Recycler - CPI BNA6 ADVANCE User Manual

Operate
4.4.2

Refilling loading module of BNR Advance note recycler

The optional loading module is empty and can no longer feed the recycling modules with banknotes when the
recycling and loading modules' status LEDs are flashing red (regularly every second). A status message is sent to the
host machinne.
An empty loading module will not affect banknote acceptance.
You need the interlock system key and the loading module key to refill the loading module of the note recycler with a
larger amount of up to 250 banknotes allowing the recycling cassettes to be loaded automatically whenever required
within the recycler system and depending on its customization.
• In order to be able to lock the loading module correctly, the cassette should not be filled with more than
250 banknotes.
• The banknotes to be refilled have to meet quality requirements (see chapter 4.4.2.1 "Quality requirements
for banknotes", p. 35) and correspond to the change configuration of your note recycler. Do only refill
those banknote type(s) configured as change banknote(s) in your system.
To refill banknotes
1
Remove and open the loading module as well as its maximum level detection plate (see chapter 4.3.4 "Removing,
opening, and reinstalling optional loading module (note recycler only)", p.
2
Push the pressure plate [1] down to the stop (instruction label) [A].
The plate locks in the bottom of the cassette.
3
Use the flap hole [2] to lift, hold and unfold the yellow banknote guide flap sidewards [B].
4
Consider banknote quality requirements
from the side [C].
5
Raise and lift the guide flap [3] up again [D].
6
Close and reinstall loading module (see chapter 4.3.4 "Removing, opening, and reinstalling optional loading module (note recycler
only)", p. 24).
Provided that the loading module is filled, banknotes are transferred to the recycling modules automatically after a reset and
whenever change is running low depending on the note recycler's customized minimum change stock.
34
and place a bundle of suitable banknotes into the cassette coming
Fig. 64: Refilling loading module
BNA6 Advance & BNR Advance Note Validator and Note Recycler
24).
Fig. 65: Reinstalling loading module's banknote guide flap
Published by CPI
01_CPI_BNA6 Advance Note Validator-BNR Advance Note Recycler_User Guide_V2.0_EN