Clearing Banknote Jam - CPI BNA6 ADVANCE User Manual

BNA6 Advance & BNR Advance Note Validator and Note Recycler
Status LEDs
5.2

Clearing banknote jam

In case of a banknote jam, the note validator/recycler sends an error message to the host machine. The top status LEDs on the bezel are
flashing red (fast triple flashing). If no other LED is flashing red, the banknote is jammed in the acceptance module or passage from the
acceptance module to the cash box. If the spine's status LED or another recycler module's LED (loading or recycling module) flashes red as
well the banknote is jammed in this respective module (see chapter 5.1 "Locating and fixing errors using status LEDs", p. 37).
Please refer to the separate Service and Repair Manual whenever the banknote is jammed in a note recycler's recycling module.
Please pay attention to the following safety instructions when clearing a coin banknote jam:
01_CPI_BNA6 Advance Note Validator-BNR Advance Note Recycler_User Guide_V2.0_EN
Steady on/
flashing code Meaning
On • Wrong configuration
• Hardware error
On • Wrong configuration
• Hardware error
Note recycler flaps can crush and cut.
Keep body parts clear when opening and closing the note recycler flaps.
Moving parts inside the note recycler/validator.
Risk of injury to hands and fingers.
Keep hands away from moving parts.
Published by CPI
Troubleshoot
Remedy/hints
• Host machine to reset note
validator/recycler
•
Make sure the SW configuration
matches the unit's physical
configuration
•
Check for not armed cash box
•
Check for hardware error and replace
recycling module if necessary
• Host machine to reset note
validator/recycler
•
Make sure the SW configuration
matches the unit's physical
configuration
•
Check for not armed cash box
•
Check for hardware error and replace
affected spine module if necessary
39