Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for CPI TALOS T6
Summary of Contents for CPI TALOS T6
- Page 1 V2.0 EN...
- Page 2 Changes or modifications not expressly approved by CPI could void the user's authority to operate the equipment. The note validator has been built in accordance with state-of-the-art standards and the recognized safety directives. However, please observe the following safety instructions.
-
Page 3: Table Of Contents
Pinout Information for 30-pin Connector ..................13 Power Harnesses ........................... 14 Connector Assignment for the 9-pin Cable ..................15 Customer Supplied Cables ......................15 8.4.1 9-pin Cable ............................15 8.4.2 18-pin Cable ............................15 01_CPI_Talos T6 and T8 Note Validator_Installation Guide_V2.0_EN Published by CPI... - Page 4 Locate the following listing. Select Add to My Product, followed by View Downloads. Available documents for downloading display below the listing above. Locate the configuration coupon in the list. Click the link to download the coupon. Published by CPI 01_CPI_Talos T6 and T8 Note Validator_Installation Guide_V2.0_EN...
-
Page 5: Specifications
95% or greater at nominal conditions Note insertion Lengthwise, 4 way (face up/down, either direction) Transaction speed Approximately 4 seconds – from note insertion to completed note stacking Escrow 1 note Interface Interfaces 01_CPI_Talos T6 and T8 Note Validator_Installation Guide_V2.0_EN Published by CPI... - Page 6 Send a copy of the letter to the shipper. The Talos T6/T8 note validator is designed to fit into the standard note validator opening in most host machines and can be mounted on existing studs provided by original equipment manufacturers (OEMs).
- Page 7 Section 5 of this guide. Repeat this process for other enabled notes. When the test is complete, remove the test notes from the note magazine. The installation is now complete. 01_CPI_Talos T6 and T8 Note Validator_Installation Guide_V2.0_EN Published by CPI...
- Page 8 Coupon was not read. Confirm the coupon is correct and try again. The coupon selection is stored in the unit until it is reprogrammed, even if the power is off. Published by CPI 01_CPI_Talos T6 and T8 Note Validator_Installation Guide_V2.0_EN...
-
Page 9: Programming The Note Validator With The Configuration Coupon
Note or vend coupon is disabled. The unit will remain in configuration mode until there is 30 seconds of inactivity or the note magazine is removed and reinstalled. The unit then returns to normal operation. 01_CPI_Talos T6 and T8 Note Validator_Installation Guide_V2.0_EN Published by CPI... -
Page 10: Interfaces
For further information on either interface harnesses or mounting kits, please contact your supplier or go to CPI Support and select Service Partners to find a CPI Authorized Service Center near you. Published by CPI 01_CPI_Talos T6 and T8 Note Validator_Installation Guide_V2.0_EN... -
Page 11: Cleaning
The note validator can be cleaned while it is mounted in the host machine. Follow the cleaning procedures below: Risk of electric shock. Ensure host machine power is OFF when installing, maintaining, or cleaning the Talos T6/T8 note validator. Electric shock can cause serious injury or death. Remove power from the host machine. -
Page 12: Conditions And Recovery Steps
Reattach the note magazine in the note validator. Note validator stacker is Continuous fast full Empty the note magazine in the note validator. Continuous slow Note validator is defective Replace the note validator. Published by CPI 01_CPI_Talos T6 and T8 Note Validator_Installation Guide_V2.0_EN... -
Page 13: Pinout Information For 30-Pin Connector
* “NOT” indicates that the input/output pin function is active LOW. Active LOW is a term used to describe the logic state of an integrated circuit (IC) pin. When an active LOW pin is low (signal ground), the function of that pin is active. 01_CPI_Talos T6 and T8 Note Validator_Installation Guide_V2.0_EN Published by CPI... - Page 14 (IC) pin. When an active LOW pin is low (signal ground), the function of that pin is active. Part Number Power Specification 25007706C 115 VAC 250075007C 24 VAC 250070079C 12 VDC Published by CPI 01_CPI_Talos T6 and T8 Note Validator_Installation Guide_V2.0_EN...
- Page 15 Male Pin 22-18 AWG #22 Gauge Wire Recommended AMP MODU 18-pin Mating Connector AMP Part Number Description 102398-7 IDC Connector Housing 102536-7 18-pin Back Cover 102681-4 18-pin Front Cover #22 Gauge Wire Recommended 01_CPI_Talos T6 and T8 Note Validator_Installation Guide_V2.0_EN Published by CPI...
- Page 16 ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ ___________________________________________________________________________________________________________ Published by CPI 01_CPI_Talos T6 and T8 Note Validator_Installation Guide_V2.0_EN...
- Page 17 (natural or computer) without the prior written permission of Crane Payment Innovations (CPI). CPI reserves the right to change the product specifications at any time. While every effort has been made to ensure that the information in this publication is accurate, CPI disclaims any liability for any direct or indirect losses (howsoever caused) arising out of use or reliance on this information.
- Page 18 Crane Payment Innovations Corporate HQ 3222 Phoenixville Pike, Suite 200 Malvern, PA 19355 support@cranepi.com CPI support...
Need help?
Do you have a question about the TALOS T6 and is the answer not in the manual?
Questions and answers