Programming The Note Validator With The Configuration Coupon - CPI TALOS T6 Installation Manual

Talos™ T6/T8 Note Validator
See chapter 4.1
To enable or disable notes or vend coupons on the note validator:
Remove the note magazine.
Use a pencil or screwdriver
configuration mode.
Reattach the note magazine.
Insert the note or vend coupon.
The bezel LEDs flash when the note or vend coupon is returned.
Count the flashes to determine the outcome using the chart below.
No. of Flashes
10
7
3
The unit will remain in configuration mode until there is 30 seconds of inactivity or the note magazine is removed and reinstalled. The
unit then returns to normal operation.
01_CPI_Talos T6 and T8 Note Validator_Installation Guide_V2.0_EN
"Programming the Note Validator with the Configuration
2
to press the configuration button to enter
Meaning
Note or vend coupon is successfully enabled.
Note validator is unable to read the note or vend coupon. Try
again.
Note or vend coupon is disabled.
Coupon", p 8 for related instructions.
Published by CPI
2
9