CPI BNA6 ADVANCE User Manual page 17

BNA6 Advance & BNR Advance Note Validator and Note Recycler
5
Lift rear green lever [4], hold it [C] and simultaneously slide acceptance
module towards the front as far as it will go and until it clicks into place [C].
The acceptance module is locked in place now.
6
Push rear green lever [4] back [D], hold it and reconnect acceptance module's
6-pin plug [5] to spine board's connector [6] [D].
7
Close spine flap again (see chapter 4.3.2 "Opening and closing chassis flaps",
p. 20).
The rear of the acceptance module is flush with the chassis.
8
Push green shockblocker lever [7] back in its initial position [E].
9
Reinstall cash box (see chapter 4.3.3 "Removing and reinstalling cash box",
p. Error! Bookmark not defined.) and relock interlock system (see
chapter 4.3.1 "Unlocking and relocking interlock system", p. 20).
10
Connect note validator/recycler to the PC with the STS Advance support
software installed to test the device (see separate Service and Repair Manual
and support software user guide).
01_CPI_BNA6 Advance Note Validator-BNR Advance Note Recycler_User Guide_V2.0_EN
Fig. 29: Locking acceptance module into place
Published by CPI
Fig. 30: Connecting acceptance module
Fig. 31: Reinstall shockblocker lever
Install
17